APC Power-Saving Back-UPS Pro 550

BR550GI Features

APC Power-Saving Back-UPS Pro 550

• Audible alarms
  Provides notification of changing utility power and UPS power conditions
• Automatic self-test
  Periodic battery self-test ensures early detection of a battery that needs to be replaced.
• Automatic Voltage Regulation (AVR)
  Automatically steps up low voltage and steps down high voltage to levels that are suitable for your equipment.
• Battery failure notification
  Provides early-warning fault analysis on batteries enabling timely preventive maintenance
• Battery replacement without tools
  Enables fast battery replacement, lowering Mean Time to Repair (MTTR).
• Battery-protected and surge-only outlets
  Reserves power capacity and run time for connected equipment that require UPS battery back-up while providing surge only protection for less critical equipment
• Boost and Trim Automatic Voltage Regulation (AVR)
  Eliminates voltage fluctuations as a source of AV signal degradation and component power-supply stress.
• Cold-start capable
  Provides temporary battery power when the utility power is out.
• Dataline surge protection
  Provides protection of connected equipment from power surges on the data lines.
• Disconnected battery notification
  Warns when a battery is not available to provide backup power.
• Green mode
  Patent-pending operating mode that bypasses unused electrical components in good power conditions to achieve very high operating efficiency without sacrificing any protection.
• Hot-swappable batteries
  Ensures clean, uninterrupted power to protected equipment while batteries are being replaced
• LCD graphics display
  Text and mimic diagrams that display modes of operation, system parameters and alarms.
• Power-saving outlets
  Automatically cuts power to idle equipment to conserve electricity.
• Safety-agency approved
  Ensures the product has been tested and approved to work safely with the connected service provider equipment and within the specified environment.
• USB connectivity
  Provides management of the UPS via a USB port (not available on all models).
• User-replaceable batteries
  Increases availability by allowing a trained user to perform upgrades and replacements of the batteries reducing Mean Time to Repair (MTTR)

Back-UPS Pro Features & Benefits

Manageability

• USB connection
  Use your PC to access additional power protection and management features for your UPS via a USB Port.
• LCD Status Display
  Provides key UPS status at a glance. Multiple status indicators with load and battery bar graphs.
• Audible alarms
  Provides notification of changing utility power and UPS power conditions
• Disconnected battery notification
  Warns when a battery is not available to provide backup power.

Marketing Features

• Battery-protected and surge-only outlets
  Reserves power capacity and run time for connected equipment that require UPS battery back-up while providing surge only protection for less critical equipment
• LCD Status Display
  Provides key UPS status at a glance. Multiple status indicators with load and battery bar graphs.
• Boost Automatic Voltage Regulation (AVR)
  Preserves battery life and maximizes runtime by correcting low voltages without discharging the battery.
• Energy Management Function
  Energy saving feature automatically power off peripherals when the a master device, usually a PC, hibernates or is shut down. Power to peripherals is immediately restored when the master device wakes up or is switched on.
• Green mode
  Patent-pending operating mode that bypasses unused electrical components in good power conditions to achieve very high operating efficiency without sacrificing any protection.

Serviceability

• Resettable circuit breaker
  Easy recovery from overloads; no need to replace a fuse.
• Simple battery replacement
  Increases UPS availability by allowing quick, easy battery replacement.

Availability

• Energy Management Function
  Energy saving feature automatically power off peripherals when the a master device, usually a PC, hibernates or is shut down. Power to peripherals is immediately restored when the master device wakes up or is switched on.
• Customizable voltage-transfer points
  Adjust the voltage points (widen or tighten the range) where your UPS transfers to battery to maximize useful battery life and protect sensitive electronics.
• Customizable voltage sensitivity
  Toggle between pre-determined voltage-transfer points depending on your power quality (high, medium or low sensitivity), maximizing useful battery life and protecting sensitive electronics.
• Boost and Trim Automatic Voltage Regulation (AVR)
  Gives higher application availability by correcting low and high voltage conditions without using the battery (not available on all models).
• Green mode
  Patent-pending operating mode that bypasses unused electrical components in good power conditions to achieve very high operating efficiency without sacrificing any protection.
• Automatic self-test
  Periodic battery self-test ensures early detection of a battery that needs to be replaced.
• Battery failure notification
  Provides early-warning fault analysis on batteries enabling timely preventive maintenance
• Cold-start capable
  Provides temporary battery power when the utility power is out.
• Intelligent battery management
  Maximizes battery performance, life, and reliability through intelligent, precision charging.
• Transformer-block spaced outlets
  Protect equipment with input transformer blocks without blocking access to other receptacles.

Protection

• Surge only outlets
  Protect secondary electronics from surges and spikes without reducing battery power used to run primary electronics during an outage.
• Battery and surge protected outlets
  Back up and protect your hardware and data during power outages, surges and spikes.
• Dataline surge protection
  Provides protection of connected equipment from power surges on the data lines.

Safety

• Safety-agency approved
  Ensures the product has been tested and approved to work safely with the connected service provider equipment and within the specified environment.

Output

• Output power capacity
  330 Watts / 550 VA
• Max Configurable Power (Watts)
  330 Watts / 550 VA
• Nominal Output Voltage
  230V
• Output Frequency (sync to mains)
  50 Hz
• Topology
  Line Interactive
• Waveform type
  Stepped approximation to a sinewave
• Output Connections
  (3) IEC 320 C13 (Battery Backup)

  (3) IEC 320 C13 (selector_surgetitle)
• Transfer Time
  6ms typical : 10ms maximum

Input

• Nominal Input Voltage
  230V
• Input frequency
  50/60 Hz +/- 3 Hz (auto sensing)
• Input Connections
  IEC-320 C14
• Input voltage range for main operations
  176 - 282 V
• Input voltage adjustable range for mains operation
  155 - 290 V
• Maximum Input Current
  6.0 A

Batteries & Runtime

• Battery type
  Maintenance-free sealed Lead-Acid battery with suspended electrolyte : leakproof
• Typical recharge time
  12 hour(s)
• Replacement Battery
  APCRBC110
• RBC Quantity
  1
• Battery Volt-Amp-Hour Capacity
  66
• Runtime
  View Runtime Graph
  View Runtime Chart
• Efficiency
  View Efficiency Graph

Communications & Management

• Interface Port(s)
  Optional Simple Signalling RS232 cable , USB
• Control panel
  Multi-function LCD status and control console
• Audible Alarm
  Alarm when on battery : distinctive low battery alarm : overload continuous tone alarm

Surge Protection and Filtering

• Surge energy rating
  420 Joules
• Data Line Protection
  Network line - 10/100/1000 Base-T Ethernet (RJ-45 connector)
• Filtering
  Full time multi-pole noise filtering :10% of IEEE surge let-thgouh : zero clamping response time: instantaneous

Physical

• Maximum Height
  190 , 19.0 cm
• Maximum Width
  91 , 9.1 cm
• Maximum Depth
  310 , 31.0 cm
• Net Weight
  6.53 kg
• Shipping weight
  7.71 kg
• Shipping Height
  252 , 25.2 cm
• Shipping Width
  138 , 13.8 cm
• Shipping Depth
  442 , 44.2 cm
• Color
  Black
• Master Carton Units
  2.0
• Master Carton Weight
  15.94
• Units per Pallet
  48.0
• SCC Codes
  1073130426688 1

Environmental

• Operating Environment
  0 - 40 °C
• Operating Relative Humidity
  0 - 95 %
• Operating Elevation
  0-3000 meters
• Storage Temperature
  -15 - 45 °C
• Storage Relative Humidity
  0 - 95 %
• Storage Elevation
  0-15000 meters
• Audible noise at 1 meter from surface of unit
  45.0 dBA

Conformance

• Approvals
  A-tick, C-tick, CE, GOST, GS Mark
• Equipment protection policy
  Lifetime : 200000 AUD, Lifetime : 150000 Euros, Lifetime : 75000 GBP
• Standard warranty
  2 years repair or replace, 3 years repair or replace for European Union countries

Sustainable Offer Status

• RoHS
  Compliant
• REACH
  REACH: Contains No SVHCs
• PEP
  Available in Documentation tab
• EOLI
  Available in Documentation tab